You are here: Experiment Guide > Imaging Modes > TappingMode AFM > Check Initial Scan Parameters

Check Initial Scan Parameters

For TappingMode in air, set the following initial scan parameters in the Scan Controls panel:

Scan Panel

Feedback Panel

NOTE: The Drive Frequency and Drive Amplitude values were determined during the Cantilever Tune procedure. It is not necessary to enter a value for the Amplitude Setpoint; this will be determined automatically during the engage process, but should be optimized after engage by using Surface Tune.

Other Parameters

Channels

Previous steps:

  1. Set Up the Experiment
  2. Scanner, Probe, and Sample Preparation
  3. Locate the Probe Tip
  4. Tune the Cantilever
  5. Focus Surface

Next steps:

  1. Engage and Scan

 

www.bruker.com Bruker Corporation
www.brukerafmprobes.com 112 Robin Hill Rd.
nanoscaleworld.bruker-axs.com/nanoscaleworld/ Santa Barbara, CA 93117
   
  Customer Support: (800) 873-9750
  Copyright 2010, 2011. All Rights Reserved.